SPEAR1310 datasheet(44/57 Pages) STMICROELECTRONICS

44 / 57 page

Expansion interface (EXPI)

SPEAr1310

44/57

Doc ID 17528 Rev 4

Expansion interface (EXPI)

The auxiliary bidirectional interface (EXPI) is multiplexed with the programmable PL_GPIOs

signals to connect an external component (for instance, emulation FPGA).

SPEAr1310 provides an AHB master (81) and an AHB slave (I) interface that are used by

the EXPI block in order to give access from the external world to the internal resources and

vice versa.

The EXPI is in charge of decoupling outside speed from the internal speed on the bus using

asynchronous bridges taking also care of multiplexing the first 100 PL_GPIO and the 4

PL_CLK between RAS and its functionality.

29.1

Main features

●

Master and slave mode supported

●

Full connectivity between SPEAr1310 IAs and EXPI TA port

●

Configurable internal/external sources for clock and reset

●

Configurable internal source clock operating frequency

●

16 dedicated PL_GPIOs for DMA handshaking.

–

Up to 5 handshaking interfaces with programmable flow control (3 signals):

–

Up to 8 handshaking interface with DMA flow control without TC (2 signals)

●

Handshaking interface programmability

●

Reduced 24 bit addressing mode with translation table

●

8 more signals can be used

–

Other 3 handshaking interfaces with programmable flow control

–

Other 4 handshaking interface with DMA flow control without TC

●

4 interrupt signal from external to SoC

●

1 interrupt signal from SoC to external

SPEAR1310 Fiches technique(PDF) 44 Page - STMicroelectronics

SPEAR1310 Fiches technique(HTML) 44 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57

Fiches technique Télécharger

Lien URL