ST10F280_12 datasheet(42/239 Pages) STMICROELECTRONICS

42 / 239 page

Internal Flash memory

ST10F280

42/239

Doc ID 8673 Rev. 3

for block addresses make sure that address bit A15 and A14 of the block address are

reflected in both LSBs of the selected DPPS.

Note:

For Command Instructions, address bit A14, A15, A16, A17 and A18 are don’t care. This

simplify a lot the application software, because it minimize the use of DPP registers when

using Command in the Command Interface.

Direct addressing is not allowed for Command sequence operations to the Flash. Only

5.5.2

Basic Flash access control

When accessing the Flash all command write addresses have to be located within the active

Flash memory space. The active Flash memory space is that logical address range which is

covered by the Flash after mapping. When using data page pointer (DPP) for addressing the

Flash, make sure that address bit A15 and A14 of the command addresses are reflected in

both LSBs of the selected data page pointer (A15 DPPx.1 and A14 DPPx.0).

In case of the command write addresses, address bit A14, A15 and above are “don’t care”.

Thus, command writes can be performed by only using one DPP register. This allows to

have a simpler and more compact application software.

Another advantageous possibility is to use the extended segment instruction for addressing.

Note:

The direct addressing mode is not allowed for write access to the Flash address/command

to Flash module always the indirect addressing mode has to be selected.

The following basic instruction sequences show examples for different addressing

possibilities.

Principle example of address generation for Flash commands and registers:

When using data page pointer (DPP0 is this example)

MOV DPP0,#08h

;adjust data page pointers according to the

;addresses: DPP0 is used in this example, thus

;ADDRESS must have A14 and A15 bit set to ‘0’.

MOV Rwm,#ADDRESS

;ADDRESS could be a dedicated command sequence

;address 2AA8h, 1554h ... ) or the Flash write

;address

MOV Rwn,#DATA

;DATA could be a dedicated command sequence data

;(xxA0h,xx80h ... ) or data to be programmed

MOV [Rwm],Rwn

;indirect addressing

When using the extended segment instruction:

MOV Rwm,#ADDRESS

;ADDRESS could be a dedicated command sequence

;address (2AA8h, 1554h ... ) or the Flash write

;address

MOV Rwo,#DATA

;DATA could be a dedicated command sequence data

;(xxA0h,xx80h ... ) or data to be programmed

MOV Rwn,#SEGMENT

;the value of SEGMENT represents the segment

;number and could be 0, 1, 2, 3 or 4 (depending

;on sector mapping) for 256KByte Flash.

ST10F280 Fiches technique(PDF) 42 Page - STMicroelectronics

ST10F280 Fiches technique(HTML) 42 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Fiches technique Télécharger

Lien URL