SPEAR320 datasheet(34/73 Pages) STMICROELECTRONICS

34 / 73 page

Pin description

SPEAr320

34/73

Doc ID 16755 Rev 5

Printer mode

The “printer” operating mode mainly provides:

●

NAND Flash interface (8 bits, 4 chip selects)

●

Up to 4 PWM outputs

●

2 SMII interfaces

●

3 UARTs

–

1 with hardware flow control (up to 3 Mbps)

–

1 with hardware flow control (baud rate up to 7 Mbps)

–

1 with software flow control (baud rate up to 7 Mbps)

●

SDIO interface supporting SPI, SD1, SD4 and SD8 mode

●

Standard Parallel Port (SPP device implementation)

●

2 independent SSP Synchronous Serial Ports (SPI, Microwire or TI protocol)

●

GPIOs with interrupt capabilities

●

4.3.3

Alternate functions

Other peripheral functions are listed in the Alternate Functions column of Table 11:

PL_GPIO multiplexing scheme and can be individually enabled/disabled configuring the bits

of a dedicated control register.

4.3.4

Boot pins

The status of the boot pins is read at startup by the BootROM.

4.3.5

GPIOs

The PL_GPIO pins can be used as software controlled general purpose I/Os (GPIOs) if they

are not used by the I/O functions of the SPEAr320 IPs.

To configure any PL_GPIO pin as GPIO, set the corresponding bit in the GPIO_Select(0 ..3)

registers that are 102 bits write registers that select GPIO versus some IPs.

SPEAR320 Fiches technique(PDF) 34 Page - STMicroelectronics

SPEAR320 Fiches technique(HTML) 34 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73

Fiches technique Télécharger

Lien URL