SPBT2532C2AT datasheet(27/48 Pages) STMICROELECTRONICS

27 / 48 page

SPBT2532C2.AT

Commands

Doc ID 16089 Rev 3

27/48

C.5.2

Responses

If the change is accepted, the response is:

AT-AB Baudrate Changed

C.6

DefaultLocalName

The DefaultLocalName command is used to set the name of the device to the name that is

reported during device discoveries. By default, the abSerial interface uses

“Amp’edBTDevice”. Changing the name using this command will permanently change the

local name, unlike the LocalName command.

C.6.1

Syntax

AT+AB DefaultLocalName [name]

Where

[name] is a string for the new local name (up to 50 characters). The space character

is allowed; the name is assumed to be all text up to the end of the command.

C.6.2

Responses

If the operation is successful, the response is:

AT-AB LocalNameOk

C.7

DeleteSmartCable

The DeleteSmartCable command removes the current Smart Cable settings that were

entered using the SmartCableSetup command, but not the setting from the dynamic

configuration. The Smart Cable will then be deactivated for the remainder of this session.

Upon reset, if a dynamic configuration for a Smart Cable exists, it will be activated. If there is

no dynamic configuration Smart Cable setup, then this feature will remain deactivated.

C.7.1

Syntax

AT+AB DeleteSmartCable

C.7.2

Responses

If the operation is successful, the response is:

AT-AB DeleteSmartCableDone

SPBT2532C2AT Fiches technique(PDF) 27 Page - STMicroelectronics