AX2000 datasheet(72/262 Pages) MICROSEMI

72 / 262 page

Detailed Specifications

2- 58

R e v i sio n 1 8

R-Cell

Introduction

The R-cell, the sequential logic resource of the Axcelerator devices, is the second logic module type in

the AX family architecture. It includes clock inputs for all eight global resources of the Axcelerator

architecture as well as global presets and clears (Figure 2-31).

The main features of the R-cell include the following:

•

Direct connection to the adjacent logic module through the hardwired connection DCIN. DCIN is

driven by the DCOUT of an adjacent C-cell via the Direct-Connect routing resource, providing a

connection with less than 0.1 ns of routing delay.

•

The R-cell can be used as a standalone flip-flop. It can be driven by any C-cell or I/O modules

through the regular routing structure (using DIN as a routable data input). This gives the option of

using the R-Cell as a 2:1 MUXed flip-flop as well.

•

Provision of data enable-input (S0).

•

Independent active-low asynchronous clear (CLR).

•

Independent active-low asynchronous preset (PSET). If both CLR and PSET are low, CLR has

higher priority.

•

Clock can be driven by any of the following (CKP selects clock polarity):

– One of the four high performance hardwired fast clocks (HCLKs)

– One of the four routed clocks (CLKs)

– User signals

•

Global power-on clear (GCLR) and preset (GPSET), which drive each flip-flop on a chip-wide

basis.

– When the Global Set Fuse option in the Designer software is unchecked (by default),

GCLR = 0 and GPSET = 1 at device power-up. When the option is checked, GCLR = 1 and

GPSET = 0. Both pins are pulled High when the device is in user mode. Refer to the

"Simulation Support for GCLR/GPSET in Axcelerator" section of the Antifuse Macro Library

Guide

for information on simulation support for GCLR and GPSET.

•

S0, S1, PSET, and CLR can be driven by routed clocks CLKE/F/G/H or user signals.

•

DIN and S1 can be driven by user signals.

As with the C-cell, the configuration of the R-cell to perform various functions is handled automatically for

the user through Microsemi's extensive macro library (see the Antifuse Macro Library Guide for a

complete listing of available AX macros).

Figure 2-31 • R-Cell

DCIN

DIN(user signals)

HCLKA/B/C/D

CLKE/F/G/H

Internal Logic

AX2000 Fiches technique(PDF) 72 Page - Microsemi Corporation

AX2000 Fiches technique(HTML) 72 Page - Microsemi Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Fiches technique Télécharger

Lien URL