HC705CT4GRSSLASHD datasheet(20/152 Pages) NXP

20 / 152 page

General Description

General Release Specification

MC68HC705CT4 — Rev. 2.0

General Description

MOTOROLA

1.4 Signal Description

The following paragraphs describe the signals.

1.4.1 VDD and VSS

Power is supplied to the microcontroller’s digital circuits using these two

pins. VDD is the positive supply and VSS is ground.

1.4.2 VDD2 and VSS2

Power is supplied to noise-susceptible circuitry such as the phase-

locked loop (PLL), comparators, and oscillators that require “cleaner”

supplies using these two pins. VDD2 is the positive supply and VSS2 is

ground.

1.4.3 Maskable Interrupt Request (IRQ/VPP)

This pin supplies the EPROM with the required programming voltage. In

addition, this pin has a mask option as specified by the user that

provides one of two different choices of interrupt triggering sensitivity.

The options are:

1. Negative edge-sensitive triggering only

2. Both negative edge-sensitive and level-sensitive triggering

The microcontroller unit (MCU) completes the current instruction before

it responds to the interrupt request. When IRQ goes low for at least one

tILIH, a logic 1 is latched internally to signify that an interrupt has been

requested. When the MCU completes its current instruction, the interrupt

latch is tested. If the interrupt latch contains a logic 1 and the interrupt

mask bit (I bit) in the condition code register is clear, the MCU then

begins the interrupt sequence.

If the option is selected to include level-sensitive triggering, the IRQ input

requires an external resistor to VDD for wire-OR operation.

Freescale Semiconductor, Inc.

For More Information On This Product,

Go to: www.freescale.com

HC705CT4GRS/D Fiches technique(PDF) 20 Page - NXP Semiconductors