LT6232 datasheet(16/30 Pages) AD

No de pièce	LT6232

Description	0.88nV/√Hz 730MHz, 500V/μs, Low Distortion Rail-to-Rail Output Op Amps with Shutdown

PDF	30 Pages

Scroll/Zoom	100%

Fabricant	AD [Analog Devices]

Site Internet	http://www.analog.com

Logo

16 / 30 page

LTC6228/LTC6229

Rev. B

For more information www.analog.com

PIN FUNCTIONS

FB (SOIC-8 Only): Feedback Pin. Internally connected to

OUT.

+IN: Non-Inverting Input of Amplifier. Valid input range is

from V– to V+ – 1.2V

–IN: Inverting Input of Amplifier. Valid input range is from

V– to V+ – 1.2V

OUT: Output of the Amplifier. Swings rail to rail and can

typically source/sink more than 90mA of current.

SHDN: Shutdown Pin (Active Low). Referenced to V+.

When taken 2.75V below V+, the amplifier shuts down

and enters low power mode, with the outputs in a high

impedance state. When taken to within 350mV of V+, bias

current cancellation is enabled. When left floating, the

amplifier is on but bias cancellation is not enabled.

V+: Positive Supply to Amplifier. Valid range is from 2.8V

to 11.75V when V– is 0V.

V–: Negative Supply to Amplifier. Typically 0V. This can be

made a negative voltage as long as 2.8V ≤ (V+ – V–) ≤ 11.75V

LT6232 Fiches technique(PDF) 16 Page - Analog Devices