IMX6SDLCEC datasheet(9/169 Pages) NXP

9 / 169 page

Introduction

i.MX 6Solo/6DualLite Applications Processors for Consumer Products, Rev. 9, 11/2018

NXP Semiconductors

•

A-HAB—Advanced High Assurance Boot—HABv4 with the new embedded enhancements:

SHA-256, 2048-bit RSA key, version control mechanism, warm boot, CSU, and TZ initialization.

NOTE

The actual feature set depends on the part numbers as described in Table 1,

"Example Orderable Part Numbers," on page 3. Functions, such as video

hardware acceleration, and 2D and 3D hardware graphics acceleration may

not be enabled for specific part numbers.

1.3

Updated Signal Naming Convention

The signal names of the i.MX6 series of products have been standardized to better align the signal names

within the family and across the documentation. Some of the benefits of these changes are as follows:

•

The names are unique within the scope of an SoC and within the series of products

•

Searches will return all occurrences of the named signal

•

The names are consistent between i.MX 6 series products implementing the same modules

•

The module instance is incorporated into the signal name

This change applies only to signal names. The original ball names have been preserved to prevent the need

to change schematics, BSDL models, IBIS models, etc.

Throughout this document, the updated signal names are used except where referenced as a ball name

(such as the Functional Contact Assignments table, Ball Map table, and so on). A master list of the signal

name changes is in the document, IMX 6 Series Signal Name Mapping (EB792). This list can be used to

map the signal names used in older documentation to the new standardized naming conventions.

IMX6SDLCEC Fiches technique(PDF) 9 Page - NXP Semiconductors