IMX6SDLCEC datasheet(87/169 Pages) NXP

87 / 169 page

Electrical Characteristics

i.MX 6Solo/6DualLite Applications Processors for Consumer Products, Rev. 9, 11/2018

NXP Semiconductors

Figure 50. RGMII Receive Signal Timing Diagram with Internal Delay

4.11.6

Flexible Controller Area Network (FLEXCAN) AC Electrical

Specifications

The Flexible Controller Area Network (FlexCAN) module is a communication controller implementing

the CAN protocol according to the CAN 2.0B protocol specification. The processor has two CAN modules

available for systems design. Tx and Rx ports for both modules are multiplexed with other I/O pins. See

the IOMUXC chapter of the i.MX 6Solo/6DualLite Reference Manual (IMX6SDLRM) to see which pins

expose Tx and Rx pins; these ports are named FLEXCAN_TX and FLEXCAN_RX, respectively.

4.11.7

HDMI Module Timing Parameters

4.11.7.1

Latencies and Timing Information

Power-up time (time between TX_PWRON assertion and TX_READY assertion) for the HDMI 3D Tx

PHY while operating with the slowest input reference clock supported (13.5 MHz) is 3.35 ms.

Power-up time for the HDMI 3D Tx PHY while operating with the fastest input reference clock supported

(340 MHz) is 133

μs.

4.11.7.2

Electrical Characteristics

The table below provides electrical characteristics for the HDMI 3D Tx PHY. The following three figures

illustrate various definitions and measurement conditions specified in the table below.

IMX6SDLCEC Fiches technique(PDF) 87 Page - NXP Semiconductors