JS28F256P30T85 datasheet(64/102 Pages) INTEL

64 / 102 page

1-Gbit P30 Family

April 2005

Intel StrataFlash® Embedded Memory (P30)

Datasheet

Order Number: 306666, Revision: 001

11.3.1

BEFP Requirements and Considerations

BEFP requirements:

• Case temperature: TC = 25 °C ± 5 °C

• VCC within specified operating range

• VPP driven to VPPH

• Target block unlocked before issuing the BEFP Setup and Confirm commands

• The first-word address (WA0) for the block to be programmed must be held constant from the

setup phase through all data streaming into the target block, until transition to the exit phase is

desired

• WA0 must align with the start of an array buffer boundary1

BEFP considerations:

• For optimum performance, cycling must be limited below 100 erase cycles per block2

• BEFP programs one block at a time; all buffer data must fall within a single block3

• BEFP cannot be suspended

• Programming to the flash memory array can occur only when the buffer is full4

NOTES:

Word buffer boundaries in the array are determined by A[4:0] (0x00 through 0x1F). The alignment start

point is A[4:0] = 0x00.

Some degradation in performance may occur if this limit is exceeded, but the internal algorithm

continues to work properly.

If the internal address counter increments beyond the block's maximum address, addressing wraps

around to the beginning of the block.

If the number of words is less than 32, remaining locations must be filled with 0xFFFF.

11.3.2

BEFP Setup Phase

After receiving the BEFP Setup and Confirm command sequence, Status Register bit SR[7]

(Ready) is cleared, indicating that the WSM is busy with BEFP algorithm startup. A delay before

checking SR[7] is required to allow the WSM enough time to perform all of its setups and checks

(Block-Lock status, VPP level, etc.). If an error is detected, SR[4] is set and BEFP operation

terminates. If the block was found to be locked, SR[1] is also set. SR[3] is set if the error occurred

due to an incorrect VPP level.

Note:

Reading from the device after the BEFP Setup and Confirm command sequence outputs Status

loaded into the buffer.

11.3.3

BEFP Program/Verify Phase

After the BEFP Setup Phase has completed, the host programming system must check SR[7,0] to

determine the availability of the write buffer for data streaming. SR[7] cleared indicates the device

is busy and the BEFP program/verify phase is activated. SR[0] indicates the write buffer is

available.

JS28F256P30T85 Fiches technique(PDF) 64 Page - Intel Corporation

JS28F256P30T85 Fiches technique(HTML) 64 Page - Intel Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Fiches technique Télécharger

Lien URL