STV9937 datasheet(43/49 Pages) STMICROELECTRONICS

No de pièce	STV9937

Description	120-MHz On-Screen Display for Monitors including PictureBooSTTM and 4 True Independent Window Displays

PDF	49 Pages

Scroll/Zoom	100%

Fabricant	STMICROELECTRONICS [STMicroelectronics]

Site Internet	http://www.st.com

Logo

43 / 49 page

43/49

STV9937

Application Hints

Re-allocation, reset, and writing new characters in windows

1. Disable windows.

2. Write new allocations.

3. Reset the windows.

4. Write new positions and sizes in control registers.

5. Write new color-boxes.

6. Write new characters and color-box data.

7. Enable windows.

10.2

Hardware Hints

●

The serial resistors on the ROUT, GOUT, BOUT, FBLK and PB outputs must be as close as

possible to the device.

●

Both decoupling capacitors (100 nF and 100 µF) must be as close as possible to the analog

(pin 13) and digital (pin5) power supplies (see Figure 15).

●

PLL network must be close to the device but far from the ROUT, GOUT, BOUT, FBLK and PB

outputs. PLL network and ROUT, GOUT, BOUT and FBLK outputs should be separated by the

AVDD 3.3 V power trace.

●

PLL ground (AGND) should not be connected either to DVSS or to other grounds of the

videoboard, as the ground is already connected internally.

●

It is better to supply the STV9937 device through ferrite beads (as an example the ferrite bead

could be 742 760 5 type from Würth Electronik) instead of traditional inductance that could

damage the OSD jitter with some parasitic resonance.

STV9937 Fiches technique(PDF) 43 Page - STMicroelectronics