UM0324 datasheet(13/105 Pages) STMICROELECTRONICS

13 / 105 page

UM0324

Getting started with tools

13/105

1.3.3

Starting the IAR toolchain

When you have installed the toolchain, you can open the workspace directly from the

dedicated folder, by double-clicking on the IFOC.eww file:

The file location is:

\ FOC_AC_SR_v1.0 \ IAR \ IFOC.eww

1.4

Customizing the workspace for your STR750X derivative

The AC IM IFOC software library was written for the STR750FVT2. However, it works

equally successfully with all the products in the STR75x family.

Using a different STR750 sales type may require some modifications to the library,

according to the available features (some of the I/O ports are not present on low-pin count

packages). Refer to the datasheet for further details.

Also, depending on the memory size, the workspace may have to be configured to fit your

STR75x MCU derivative.

Figure 3.

Device summary

1.4.1

Inkarm_xxx.xcl

file (internal/external flash or RAM based project)

The IAR\config folder contains 3 files:

●

Inkarm_flash.xcl

●

Inkarm_smi.xcl

●

Inkarm_ram.xcl

These files are used as an extended command linker file and contain linker options. Memory

areas, start address, size, and other parameters are declared here. It also contains the

value assigned to the stack size for each ARM operating mode (for example, USER or FIQ.

Refer to the ARM7TDMI-S Technical Reference Manual for more information).

UM0324 Fiches technique(PDF) 13 Page - STMicroelectronics