 |
Moteur de recherche de fiches techniques de composants électroniques |
|
|
Moteur de recherche de fiches techniques de composants électroniques |
|
PM0073 Fiches technique(PDF) 19 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
PM0073 Fiches technique(HTML) 19 Page - STMicroelectronics |
|
|
19 / 34 page  PM0073 Reading/programming the STM32Wxxx embedded Flash memory Doc ID 17766 Rev 5 19/34 Erase procedure The option byte erase sequence (OPTERASE) is as follows: 1. Enable the FPEC clock. 2. Check that no Flash memory operation is ongoing by reading the BSY bit in the FLASH_SR register. 3. Unlock the OPTWRE bit in the FLASH_CR register. 4. Set the OPTER bit in the FLASH_CR register. 5. Set the STRT bit in the FLASH_CR register. 6. Wait for BSY to reset. 7. Read the erased option bytes and verify. 2.3 Protections The user area of the Flash memory can be protected against read by untrusted code. The pages of the Flash memory can also be protected against unwanted write due to loss of program counter contexts. The write-protection granularity is four pages. 2.3.1 Read protection The read protection is activated by setting the RDP option byte, and then by applying a system reset to reload the new RDP option byte. Note: If the read protection is set while the debugger is still connected through JTAG/SWD, apply a POR (power-on reset) instead of a system reset (without debugger connection). Once the protection byte has been programmed: ● Main Flash memory read access is not allowed except for the user code (when booting from main Flash memory itself with the debug mode not active). ● Pages 0-3 are automatically write-protected. The rest of the memory can be programmed by the code executed from the main Flash memory (for IAP, constant storage, etc.); it is protected against write/erase (but not against mass erase) in debug mode or when booting from the embedded SRAM. ● All features linked to loading code into and executing code from the embedded SRAM are still active (JTAG/SWD and boot from embedded SRAM) and this can be used to disable the read protection. When the read protection option byte is altered to a memory-unprotect value, a mass erase is performed. ● Flash memory access through data read using JTAG, SWV (serial wire viewer), SWD (serial wire debug) and boundary scan are not allowed. |
|
Lien URL |
| ALLDATASHEET vous a-t-il été utile ? [ DONATE ] |
À propos de Alldatasheet | Publicité | Contactez-nous | Politique de confidentialité | Lien vers la fiche technique | Echange de liens | Fabricants All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |
French ▼
English
Chinese
German
Japanese
Russian
Korean
Spanish
French
Italian
Portuguese
Polish
Vietnamese
Indian
Mexican
British
New Zealand
