D201GLY datasheet(18/76 Pages) INTEL

18 / 76 page

Intel Desktop Board D201GLY Technical Product Specification

1.5.3

IDE Support

The board provides one parallel ATA IDE connector that supports two devices.

1.5.3.1

Parallel ATA IDE Interface

The D201GLY board has one bus-mastering Parallel ATA IDE interface. The Parallel

ATA IDE interface supports the following modes:

•

Programmed I/O (PIO): processor controls data transfer.

•

8237-style DMA: DMA offloads the processor, supporting transfer rates of up to

16 MB/sec.

•

Ultra DMA: DMA protocol on IDE bus supporting host and target throttling and

transfer rates of up to 33 MB/sec.

•

ATA-66: DMA protocol on IDE bus supporting host and target throttling and

transfer rates of up to 66 MB/sec. ATA-66 protocol is similar to Ultra DMA and is

device driver compatible.

•

ATA-100: DMA protocol on IDE bus allows host and target throttling. The

SiS964L’s ATA-100 logic can achieve read transfer rates up to 100 MB/sec and write

transfer rates up to 88 MB/sec.

NOTE

ATA-66 and ATA-100 are faster timings and require a specialized cable to reduce

reflections, noise, and inductive coupling.

The Parallel ATA IDE interface also supports ATAPI devices (such as CD-ROM drives)

and ATA devices using the transfer modes.

For information about

Refer to

The location of the Parallel ATA IDE connector

Figure 7, page 38

D201GLY Fiches technique(PDF) 18 Page - Intel Corporation