ATtiny10 datasheet(37/168 Pages) ATMEL

37 / 168 page

8127C–AVR–10/09

ATtiny4/5/9/10

Figure 9-1.

Timing of pin change interrupts

9.3

9.3.1

EICRA – External Interrupt Control Register A

The External Interrupt Control Register A contains control bits for interrupt sense control.

• Bits 7:2 – Res: Reserved Bits

These bits are reserved and will always read zero.

• Bits 1:0 – ISC01, ISC00: Interrupt Sense Control 0 Bit 1 and Bit 0

The External Interrupt 0 is activated by the external pin INT0 if the SREG I-flag and the corre-

sponding interrupt mask are set. The level and edges on the external INT0 pin that activate the

interrupt are defined in Table 9-2. The value on the INT0 pin is sampled before detecting edges.

If edge or toggle interrupt is selected, pulses that last longer than one clock period will generate

an interrupt. Shorter pulses are not guaranteed to generate an interrupt. If low level interrupt is

clk

PCINT(0)

pin_lat

pin_sync

pcint_in_(0)

pcint_syn

pcint_setflag

PCIF

PCINT(0)

pin_sync

pcint_syn

pin_lat

pcint_setflag

PCIF

clk

PCINT(0) in PCMSK(x)

pcint_in_(0)

Bit

765

432

0x15

–

ISC01

ISC00

EICRA

Read/Write

RRR

R/W

Initial Value

ATtiny10 Fiches technique(PDF) 37 Page - ATMEL Corporation

ATtiny10 Fiches technique(HTML) 37 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Fiches technique Télécharger

Lien URL