ATtiny10 datasheet(30/168 Pages) ATMEL

30 / 168 page

8127C–AVR–10/09

ATtiny4/5/9/10

Figure 8-5.

Watchdog Reset During Operation

8.3

Watchdog Timer

The Watchdog Timer is clocked from an on-chip oscillator, which runs at 128 kHz. See Figure 8-

6. By controlling the Watchdog Timer prescaler, the Watchdog Reset interval can be adjusted as

shown in Table 8-2 on page 32. The WDR – Watchdog Reset – instruction resets the Watchdog

Timer. The Watchdog Timer is also reset when it is disabled and when a device reset occurs.

Ten different clock cycle periods can be selected to determine the reset period. If the reset

period expires without another Watchdog Reset, the ATtiny4/5/9/10 resets and executes from

the Reset Vector. For timing details on the Watchdog Reset, refer to Table 8-3 on page 33.

Figure 8-6.

Watchdog Timer

The Wathdog Timer can also be configured to generate an interrupt instead of a reset. This can

be very helpful when using the Watchdog to wake-up from Power-down.

To prevent unintentional disabling of the Watchdog or unintentional change of time-out period,

two different safety levels are selected by the fuse WDTON as shown in Table 8-1 on page 31.

See “Procedure for Changing the Watchdog Timer Configuration” on page 31 for details.

MCU RESET

WATCHDOG

PRESCALER

128 kHz

OSCILLATOR

WATCHDOG

RESET

WDP0

WDP1

WDP2

WDP3

WDE

MUX

ATtiny10 Fiches technique(PDF) 30 Page - ATMEL Corporation