H8SX1663 datasheet(269/1158 Pages) RENESAS

269 / 1158 page

Section 6 Bus Controller (BSC)

Rev.1.00 Jun. 07, 2006 Page 217 of 1102

REJ09B0294-0100

6.8.5

Wait Control

As with the basic bus interface, either program wait insertion or pin wait insertion by the

WAIT

pin can be used in the initial cycle (full access) on the burst ROM interface. See section 6.6.4,

Wait Control. Wait cycles cannot be inserted in a burst cycle.

6.8.6

Read Strobe (

RD) Timing

When the burst ROM space is read by the CPU, the RDNCR setting for the corresponding space is

invalid.

The read strobe negation timing is the same timing as when RDNn = 0 in the basic bus interface.

6.8.7

Extension of Chip Select (

CS) Assertion Period

In the burst ROM interface, the extension cycles can be inserted in the same way as the basic bus

interface.

For the burst ROM space, the burst access can be enabled only in read access by the CPU. In this

case, the setting of the corresponding CSXTn bit in CSACR is ignored and an extension cycle can

be inserted only before the full access cycle. Note that no extension cycle can be inserted before or

after the burst access cycles.

In accesses other than read accesses by the CPU, the burst ROM space is equivalent to the basic

bus interface space. Accordingly, extension cycles can be inserted before and after the burst access

cycles.

H8SX1663 Fiches technique(PDF) 269 Page - Renesas Technology Corp