STM32MP151A datasheet(26/253 Pages) STMICROELECTRONICS

No de pièce	STM32MP151A

Description	Arm® Cortex®-A7 800 MHz Cortex®-M4 MPU, TFT, 35 comm. interfaces, 25 timers, adv. analog

PDF	253 Pages

Scroll/Zoom	100%

Fabricant	STMICROELECTRONICS [STMicroelectronics]

Site Internet	http://www.st.com

Logo

26 / 253 page

Functional overview

STM32MP151A/D

26/253

DS12500 Rev 3

3.6

Boot modes

At startup, the boot source used by the internal BootROM is selected by the BOOT pin and

OTP bytes.

Table 2. Boot modes

BOOT2 BOOT1 BOOT0

Initial boot mode

Comments

UART and USB(1)

Wait incoming connection on:

– USART2/3/6 and UART4/5/7/8 on default pins

– USB high-speed device(2)

Serial NOR Flash(3)

Serial NOR Flash on QUADSPI(4)

e•MMC(3)

e•MMC on SDMMC2 (default)(4)(5)

NAND Flash(3)

SLC NAND Flash on FMC

Reserved (NoBoot)

Used to get debug access without boot from Flash memory

SD card(3)

SD card on SDMMC1 (default)(4)(5)

UART and USB(1)(3)

Wait incoming connection on:

– USART2/3/6 and UART4/5/7/8 on default pins

– USB high-speed device on OTG_HS_DP/DM pins(2)

Serial NAND Flash(3)

Serial NAND Flash on QUADSPI(4)

1. can be disabled by OTP settings.

2. USB requires 24 MHz HSE clock/crystal if OTP is not programmed for different frequency.

3. Boot source can be changed by OTP settings (e.g. initial boot on SD card, then e•MMC with OTP settings).

4. Default pins can be altered by OTP.

5. Alternatively, another SDMMC1 or SDMMC2 interface than this default can be selected by OTP.

STM32MP151A Fiches technique(PDF) 26 Page - STMicroelectronics