HD6432351 datasheet(259/1025 Pages) RENESAS

259 / 1025 page

Section 7 DMA Controller (DMAC)

Rev. 3.00 Sep 15, 2006 page 225 of 988

REJ09B0330-0300

Bits 6 and 4—Data Transfer Enable (DTE): When DTE = 0, data transfer is disabled and the

activation source selected by the data transfer factor setting is ignored. If the activation source is

an internal interrupt, an interrupt request is issued to the CPU or DTC. If the DTIE bit is set to 1

when DTE = 0, the DMAC regards this as indicating the end of a transfer, and issues a transfer

end interrupt request to the CPU.

The conditions for the DTE bit being cleared to 0 are as follows:

• When initialization is performed

• When the specified number of transfers have been completed

• When 0 is written to the DTE bit to forcibly abort the transfer, or for a similar reason

When DTE = 1 and DTME = 1, data transfer is enabled and the DMAC waits for a request by the

activation source selected by the data transfer factor setting. When a request is issued by the

activation source, DMA transfer is executed.

The condition for the DTE bit being set to 1 is as follows:

• When 1 is written to the DTE bit after the DTE bit is read as 0

Bit 6—Data Transfer Enable 1 (DTE1): Enables or disables data transfer on channel 1.

Bit 6

DTE1

Description

Data transfer disabled

(Initial value)

Data transfer enabled

Bit 4—Data Transfer Enable 0 (DTE0): Enables or disables data transfer on channel 0.

Bit 4

DTE0

Description

Data transfer disabled

(Initial value)

Data transfer enabled

HD6432351 Fiches technique(PDF) 259 Page - Renesas Technology Corp