7

LP5907-Q1

www.ti.com

SNVSA34E – SEPTEMBER 2014 – REVISED DECEMBER 2019

Product Folder Links: LP5907-Q1

Submit Documentation Feedback

Copyright © 2014–2019, Texas Instruments Incorporated

Electrical Characteristics (continued)

VIN = VOUT(NOM) + 1 V, VEN = 1.2 V, IOUT = 1 mA, CIN = 1 µF, COUT = 1 µF (unless otherwise noted)

(1)(2)(3)

PARAMETER

TEST CONDITIONS

MIN

TYP

MAX

UNIT

TRANSIENT CHARACTERISTICS

ΔVOUT

Line transient(8)

VIN = (VOUT(NOM) + 1 V) to

(VOUT(NOM) + 1.6 V) in 30 µs

–1

mV

VIN = (VOUT(NOM) + 1.6 V) to

(VOUT(NOM) + 1.6 V) in 30 µs

1

Load transient(8)

IOUT = 1 mA to 250 mA in 10 µs

–40

IOUT = 250 mA to 1 mA in 10 µs

40

Overshoot on start-up(8)

Stated as a percentage of VOUT(NOM)

5%

Overshoot on start-up with EN(8)

Stated as a percentage of VOUT(NOM), VIN =

VOUT + 1 V to 5.5 V, 0.7 µF < COUT < 10 µF, 0

mA < IOUT < 250 mA, EN rising until the output

is enabled

1%

tON

Turnon time

From VEN > VIH to VOUT = 95% of VOUT(NOM),

TA = 25°C

80

150

µs

(1)

The minimum capacitance should be greater than 0.5 μF over the full range of operating conditions. The capacitor tolerance should be

30% or better over the full temperature range. The full range of operating conditions for the capacitor in the application should be

considered during device selection to ensure this minimum capacitance specification is met. X7R capacitors are recommended however

capacitor types X5R, Y5V and Z5U may be used with consideration of the application and conditions.

(2)

This specification is verified by design.

6.6 Output and Input Capacitors

over operating free-air temperature range (unless otherwise noted)

PARAMETER

TEST CONDITIONS

MIN(1)

TYP

MAX

UNIT

CIN

Input capacitance(2)

Capacitance for stability

0.7

1

µF

COUT

Output capacitance(2)

0.7

1

10

ESR

Output/input capacitance(2)

5

500

mΩ