XRT7250 datasheet(89/463 Pages) EXAR

89 / 463 page

XRT7250

DS3/E3 FRAMER IC

áç

REV. 1.1.1

Bit 4 - COFA (Change of Frame Alignment) Inter-

rupt Status

This Reset-upon-Read bit-field will be set to "1" if the

Change of Frame Alignment interrupt has occurred

since the last read of this register.

The Receive E3 Framer will generate the Change of

Frame Alignment interrupt if it has detected a change

in frame alignment in the incoming E3 frames.

Bit 3 - OOF (Receive E3 Framer) Interrupt Status

This Reset Upon Read bit-field is set to "1" if the Re-

ceive E3 Framer has detected a Change in the Out-

of-Frame (OOF) Condition, since the last time this

serted under either of the following two conditions:

1. When the Receive E3 Framer has detected the

appropriate conditions to declare an OOF Condi-

tion.

2. When the Receive E3 Framer has transitioned

from the OOF Condition (Frame Acquisition

Mode) into the In-Frame Condition (Frame Main-

tenance mode).

NOTE: For more information of the OOF Condition, please

see Section 5.3.2.1.

Bit 2 - LOF (Loss of Frame) Interrupt Status

This Reset-upon-Read bit-field will be set to "1" if a

Change in LOF Condition interrupt has occurred

since the last read of this register.

The Receive E3 Framer will generate the Change in

LOF Condition interrupt is response to either of the

following two occurrences.

1. Whenever the Receive E3 Framer transitions

from the OOF Condition state into the LOF Con-

dition state, within the E3 Framing Acquisition/

Maintenance algorithm (per Figure 194).

2. Whenever the Receive E3 Framer transitions

from the FA1, FA2 Octet Verification state to the

In-frame state, within the E3 Framing Acquisition/

Maintenance algorithm (per Figure 194).

Bit 1 - LOS (Loss of Signal) Interrupt Status

This Reset Upon Read bit will be set to "1", if the Re-

ceive E3 Framer has detected a

Change in the LOS Status condition, since the last

time this register was read. This bit-field will be as-

serted under either of the following two conditions:

1. When the Receive E3 Framer detects the occur-

rence of an LOS Condition (e.g., the occurrence

of 32 consecutive spaces in the incoming E3 data

stream), and

2. When the Receive E3 Framer detects the end of

an LOS Condition (e.g., when the Receive E3

Framer detects a string 32 bits that does not con-

tain a string of four consecutive "0’s").

The local µP can determine the current state of the

LOS condition by reading bit 6 of the Rx E3 Configu-

ration and Status Register (Address = 0x11).

NOTE: For more information in the LOS of Signal (LOS)

Alarm, please see Section 5.3.2.6.

Bit 0 - AIS Interrupt Status

This Reset Upon Read bit field will be set to "1", if the

Receive E3 Framer has detected a Change in the AIS

condition, since the last time this register was read.

This bit-field will be asserted under either of the fol-

lowing two conditions:

1. When the Receive E3 Framer first detects an AIS

Condition in the incoming E3 data stream.

2. When the Receive E3 Framer has detected the

end of an AIS Condition in the incoming E3 data

stream.

The local µP can determine the current state of the

AIS condition by reading bit 7 of the Rx E3 Configura-

tion and Status Register (Address = 0x11).

NOTE: For more information on the AIS Condition please

see Section 5.3.2.6.2.

2.3.3.6

Receive E3 Interrupt Status Register -

2 (E3, ITU-T G.832)

Bit 6 - TTB Change Interrupt Status (Receipt of

New Trail Trace Buffer Message interrupt)

RXE3 INTERRUPT STATUS REGISTER - 2 (ADDRESS = 0X15)

BIT 7BIT 6BIT 5BIT 4BIT 3BIT 2BIT 1BIT 0

Not Used

TTB

Change

Interrupt

Status

Not Used

FEBE

Interrupt

Status

FERF

Interrupt

Status

BIP-8

Error Interrupt

Status

Framing

Byte Error

Interrupt

Status

RxPld

Mis

Interrupt

Status

RUR

000

XRT7250 Fiches technique(PDF) 89 Page - Exar Corporation

XRT7250 Fiches technique(HTML) 89 Page - Exar Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Fiches technique Télécharger

Lien URL