ISL6566 datasheet(8/30 Pages) RENESAS

No de pièce	ISL6566

Description	Three-Phase Buck PWM Controller with Integrated MOSFET Drivers for VRM9, VRM10, and AMD Hammer Applications

PDF	30 Pages

Scroll/Zoom	100%

Fabricant	RENESAS [Renesas Technology Corp]

Site Internet	http://www.renesas.com

Logo

8 / 30 page

ISL6566

FN9178 Rev 4.00

Page 8 of 30

Mar 9, 2006

Timing Diagram

Simplified Power System Diagram

Functional Pin Description

VCC

VCC is the bias supply for the ICs small-signal circuitry.

Connect this pin to a +5V supply and locally decouple using

a quality 1.0

F ceramic capacitor.

PVCC1, PVCC2, PVCC3

These pins are the power supply pins for the corresponding

channel MOSFET drive, and can be connected to any

voltage from +5V to +12V, depending on the desired

MOSFET gate drive level.

The number of active channels is determined by the state of

PVCC2 and PVCC3. Leave PVCC3 unconnected or

grounded for 2-phase operation. For 1-phase operation

leave both PVCC3 and PVCC2 unconnected or grounded.

GND

GND is the bias and reference ground for the IC.

ENLL

This pin is a threshold-sensitive (approximately 0.66V) enable

input for the controller. Held low, this pin disables controller

operation. Pulled high, the pin enables the controller for

operation. ENLL has a internal 1.0

A pull-up to 5V.

A resistor, placed from FS to ground, will set the switching

frequency. Refer to Equation 34 for proper resistor

calculation.

UGATE

LGATE

tFLGATE

tPDHUGATE

tRUGATE

tFUGATE

tPDHLGATE

tRLGATE

CHANNEL1

+5VIN

VOUT

ISL6566

CHANNEL2

DAC

5-6

VID

CHANNEL3

+12VIN

ISL6566 Fiches technique(PDF) 8 Page - Renesas Technology Corp

ISL6566 Fiches technique(HTML) 8 Page - Renesas Technology Corp

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Fiches technique Télécharger

Lien URL