STM32L162RE datasheet(68/129 Pages) STMICROELECTRONICS

68 / 129 page

Electrical characteristics

STM32L162xE

68/129

DocID025882 Rev 6

IDD (Stop)

Supply current in

Stop mode (RTC

disabled)

Regulator in LP mode, HSI and

HSE OFF, independent

watchdog and LSI enabled

TA = -40°C to 25°C

1.8

2.2

µA

Regulator in LP mode, LSI, HSI

and HSE OFF (no independent

watchdog)

TA = -40°C to 25°C

0.560

1.5

TA = 55°C

2.18

TA= 85°C

6.6

TA = 105°C

14.9

IDD

(WU from

Stop)

Supply current during

wakeup from Stop

mode

MSI = 4.2 MHz

TA = -40°C to 25°C

MSI = 1.05 MHz

1.45

MSI = 65 kHz(5)

1.45

1. Guaranteed by characterization results, unless otherwise specified.

2. LCD enabled with external VLCD, static duty, division ratio = 256, all pixels active, no LCD connected.

3. LCD enabled with external VLCD, 1/8 duty, 1/3 bias, division ratio = 64, all pixels active, no LCD connected.

4. Based on characterization done with a 32.768 kHz crystal (MC306-G-06Q-32.768, manufacturer JFVNY) with two 6.8 pF

loading capacitors.

5. When MSI = 64 kHz, the RMS current is measured over the first 15 µs following the wakeup event. For the remaining part

of the wakeup period, the current corresponds the Run mode current.

Table 22. Typical and maximum current consumptions in Stop mode (continued)

Symbol

Parameter

Conditions

Typ

Max(1) Unit

STM32L162RE Fiches technique(PDF) 68 Page - STMicroelectronics

STM32L162RE Fiches technique(HTML) 68 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Fiches technique Télécharger

Lien URL