AT89LS52 datasheet(5/39 Pages) ATMEL

5 / 39 page

AT89LS52

2601A–12/01

Port 3 also serves the functions of various special features of the AT89LS52, as shown in the

following table.

RST

Reset input. A high on this pin for two machine cycles while the oscillator is running resets the

device. This pin drives High for 98 oscillator periods after the Watchdog times out. The DIS-

RTO bit in SFR AUXR (address 8EH) can be used to disable this feature. In the default state

of bit DISRTO, the RESET HIGH out feature is enabled.

ALE/PROG

Address Latch Enable (ALE) is an output pulse for latching the low byte of the address during

accesses to external memory. This pin is also the program pulse input (PROG) during Flash

programming.

In normal operation, ALE is emitted at a constant rate of 1/6 the oscillator frequency and may

be used for external timing or clocking purposes. Note, however, that one ALE pulse is

skipped during each access to external data memory.

If desired, ALE operation can be disabled by setting bit 0 of SFR location 8EH. With the bit set,

ALE is active only during a MOVX or MOVC instruction. Otherwise, the pin is weakly pulled

high. Setting the ALE-disable bit has no effect if the microcontroller is in external execution

mode.

PSEN

Program Store Enable (PSEN) is the read strobe to external program memory.

When the AT89LS52 is executing code from external program memory, PSEN is activated

twice each machine cycle, except that two PSEN activations are skipped during each access

to external data memory.

EA/VPP

External Access Enable. EA must be strapped to GND in order to enable the device to fetch

code from external program memory locations starting at 0000H up to FFFFH. Note, however,

that if lock bit 1 is programmed, EA will be internally latched on reset.

EA should be strapped to V

CC for internal program executions.

This pin also receives the 12-volt programming enable voltage (V

PP ) during F l as h

programming.

XTAL1

Input to the inverting oscillator amplifier and input to the internal clock operating circuit.

XTAL2

Output from the inverting oscillator amplifier.

Port Pin

Alternate Functions

P3.0

RXD (serial input port)

P3.1

TXD (serial output port)

P3.2

INT0 (external interrupt 0)

P3.3

INT1 (external interrupt 1)

P3.4

T0 (timer 0 external input)

P3.5

T1 (timer 1 external input)

P3.6

WR (external data memory write strobe)

P3.7

RD (external data memory read strobe)

AT89LS52 Fiches technique(PDF) 5 Page - ATMEL Corporation

AT89LS52 Fiches technique(HTML) 5 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39

Fiches technique Télécharger

Lien URL