STM32F318C8 datasheet(39/125 Pages) STMICROELECTRONICS

No de pièce	STM32F318C8

Description	ARM-based Cortex-M4 32-bit MCUFPU, 64 KB Flash, 16 KB SRAM, ADC, DAC, 3 COMP, Op-Amp, 1.8 V

PDF	125 Pages

Scroll/Zoom	100%

Fabricant	STMICROELECTRONICS [STMicroelectronics]

Site Internet	http://www.st.com

Logo

39 / 125 page

BOOT0

Boot memory selection

PB8

I/O

FTf

TIM16_CH1, TSC_SYNC, I2C1_SCL,

USART3_RX TIM1_BKIN, EVENTOUT

PB9

I/O

FTf

TIM17_CH1, I2C1_SDA, IR-OUT,

USART3_TX, COMP2_OUT,

EVENTOUT

VSS_1

Digital ground

"1"

VDD_1

Digital power supply

1. PC13, PC14 and PC15 are supplied through the power switch. Since the switch sinks only a limited amount of current (3 mA), the use of GPIO PC13 to PC15 in output

mode is limited:

- The speed should not exceed 2 MHz with a maximum load of 30 pF

- These GPIOs must not be used as current sources (e.g. to drive an LED).

After the first backup domain power-up, PC13, PC14 and PC15 operate as GPIOs. Their function then depends on the content of the Backup registers which is not reset

by the main reset. For details on how to manage these GPIOs, refer to the Battery backup domain and BKP register description sections in the RM0366 reference manual.

2. These GPIOs offer a reduced touch sensing sensitivity. It is thus recommended to use them as sampling capacitor I/O.

Table 12. STM32F318x8 pin definitions (continued)

Pin Number

Pin name

(function after reset)

Alternate

functions

Additional

functions

STM32F318C8 Fiches technique(PDF) 39 Page - STMicroelectronics

STM32F318C8 Fiches technique(HTML) 39 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Fiches technique Télécharger

Lien URL