STAP16DPPS05XTTR datasheet(21/33 Pages) STMICROELECTRONICS

No de pièce	STAP16DPPS05XTTR

Description	Low voltage 16-bit constant current LED sink driver

PDF	33 Pages

Scroll/Zoom	100%

Fabricant	STMICROELECTRONICS [STMicroelectronics]

Site Internet	http://www.st.com

Logo

21 / 33 page

DocID024306 Rev 6

21/33

STAP16DPPS05

Error detection mode functionality

7.2

Phase two: error detection

The 16 data bits must be set to “1” in order to set ON all the outputs during detection. The

data are latched by LE/DM1 and after that the outputs are ready for the detection process.

When the microcontroller switches the OE/DM2 to LOW, the device drives the LEDs in order

to analyze if an OPEN or SHORT condition has occurred.

The LED status is detected in 1 microsecond (minimum) and after this time the

microcontroller sets OE/DM2 in HIGH state and the output data detection results go to the

microprocessor via SDO.

Detection mode and normal mode both use the same data format. As soon as all the

detection data bits are available on the serial line, the device may go back to normal mode

of operation. To re-detect the status, the device must go back in normal mode and re-enter

error detection mode.

Figure 19. Detection diagram

STAP16DPPS05XTTR Fiches technique(PDF) 21 Page - STMicroelectronics