M95M02-DRMN6TP datasheet(26/41 Pages) STMICROELECTRONICS

No de pièce	M95M02-DRMN6TP

Description	2-Mbit serial SPI bus EEPROM

PDF	41 Pages

Scroll/Zoom	100%

Fabricant	STMICROELECTRONICS [STMicroelectronics]

Site Internet	http://www.st.com

Logo

26 / 41 page

Instructions

M95M02-DR

26/41

DocID18203 Rev 8

6.8

Write Identification Page

The Identification Page (256 bytes) is an additional page which can be written and (later)

permanently locked in Read-only mode.

Writing this page is achieved with the Write Identification Page instruction (see Table 3). The

Chip Select signal (S) is first driven low. The bits of the instruction byte, address bytes, and

at least one data byte are then shifted in on Serial Data Input (D). Address bit A10 must be

0, upper address bits are Don't Care, the lower address bits [A7:A0] address bits define the

byte address inside the identification page. The instruction sequence is shown in Figure 16.

Figure 16. Write identification page sequence

MS30909V1

9 10

28 29 30 31 32 33 34 35

22 21

36 37 38

High impedance

Instruction

24-bit address

765432

Data byte

M95M02-DRMN6TP Fiches technique(PDF) 26 Page - STMicroelectronics