CS1630 datasheet(40/56 Pages) APEX

40 / 56 page

CS1630/31

DS954F2

6.27 Configuration 45 (Config45) – Address 77

6.28 Configuration 46 (Config46) – Address 78

654

VDIFF_LAT

MAX_CUR

Number

Name

Description

[7:2]

Reserved

[1]

VDIFF_LAT

Selects if the VDiff fault is to be a latched type fault.

0 = Unlatched fault

1 = Latched fault

[0]

MAX_CUR

Configures the second stage to draw maximum power when the boost output

voltage exceeds boost overvoltage protection threshold VBST > VBOP(th), trig-

gering a boost overvoltage fault.

0 = Disable

1 = Enable

654

WAKEUP3

WAKEUP2

WAKEUP1

WAKEUP0

Number

Name

Description

[7:4]

Reserved

[3:0]

WAKEUP[3:0]

Configures the 8-bit code value corresponding to temperature threshold

TempWakeup. Upon power-up the system will enter an external overtempera-

ture fault disabling the power train, unless the external temperature measured

at the external NTC is below TempWakeup. If the temperature drops below this

threshold, the device will clear all overtemperature faults. The setting is an off-

set to TempeOTP (see “Configuration 59 (Config59) – Address 91” on page 48

for configuring TempeOTP).

The equation above is setting 8-bit code, CODETEMPWakeup, corresponding to

temperature TempWakeup, which is in degrees Celsius. The wakeup tempera-

ture code is configured as an offset from the eOTP temperature code and the

shutdown temperature code is configured as an offset from the wakeup tem-

perature code; TempeOTP < TempWakeup < TempShutdown.

CODETEMPWakeup

CODETEMPeOTP

WAKEUP



[3:0] 4





CS1630 Fiches technique(PDF) 40 Page - Cirrus Logic

CS1630 Fiches technique(HTML) 40 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56

Fiches technique Télécharger

Lien URL