804-R010-330 datasheet(18/32 Pages) MAGNETROL

18 / 32 page

50-604 Kotron Model 804 Sentinel II RF Level Transmitter

2.5.7 System Configuration Menu (cont.)

Current Menu Location

Display

Action

Comments

Run/System Config/

Probe Calibrate

> to select

Access the Probe calibration

This is the start of the PROBE CALIBRATE menu.

Run/System Config/

Probe Calibrate

Cal Pt. #1 (LO)

> to select

Access the lower calibration

point menu

Run/System Config/

Probe Calibrate/

Cal Point #1 (LO)

Initialize

> to select

Reset the Cal Pt. #1 (LO)

to zero

The first time the unit is calibrated and when

changing “Cal Pt. #1 (LO)”, press ENT.

Otherwise press the DOWN arrow.

Run/System Config/

Probe Calibrate

Enter Password

Accept the data entered

The “Enter Password” display will not appear if

the password has been entered anywhere else

in the general program menu. Use the numeric

keys to enter your password.

Run/System Config/

Probe Calibrate/

Cal Point #1 (LO)

Calibrate

Calibrate the lower probe

reference point

Calibrate with the level as low on the probe as

possible. There must be at least 1" of level on

any insulated probe. The level entered may be

the actual level in the vessel or the number of

inches of probe coverage.

Run/System Config/

Probe Calibrate

Previous Menu

> to select

Press ENT.

Run/System Config/

Probe Calibrate

Cal Pt. #2 (HI)

> to select

Access the upper calibration

point menu

Set up for the upper calibration reference point.

Run/System Config/

Probe Calibrate/

Cal Point #2 (HI)

Initialize

> to select

Reset the Cal Pt. #2 (HI)

to zero

The first time the unit is calibrated and when

changing “Cal Pt. #2 (HI)”, press ENT.

Otherwise press the DOWN arrow.

Run/System Config/

Probe Calibrate/

Cal Point #2 (HI)

Enter Password

Probe Calibrate

Accept the data entered

The “Enter Password” display will not appear if

the password has been entered anywhere else

in the general program menu. Use the numeric

keys to enter your password.

Run/System Config/

Probe Calibrate/

Cal Point #2 (HI)

Calibrate

Calibrate the upper probe

reference point

Calibrate with the level as high on the probe as

possible. There must, however, be at minimum

2% (of span) differential between the calibration

points. A greater differential will improve accuracy.

The level entered may be the actual level in the

vessel or the number of inches of probe coverage.

Run/System Config/

Probe Calibrate

Previous Menu

> to select

Press ENT.

Run System Config

Probe Calibrate

> to select

Press DEL twice to return to the RUN mode.

Run

Magnetrol Int’l

x.x level units

Normal operation

The RUN mode.

804-R010-330 Fiches technique(PDF) 18 Page - Magnetrol International, Inc.

804-R010-330 Fiches technique(HTML) 18 Page - Magnetrol International, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Fiches technique Télécharger

Lien URL