STM8S207MBT3 datasheet(97/103 Pages) STMICROELECTRONICS

97 / 103 page

STM8S207xx, STM8S208xx

Package characteristics

Doc ID 14733 Rev 9

97/103

11.2.2

Selecting the product temperature range

When ordering the microcontroller, the temperature range is specified in the order code (see

Figure 49: STM8S207xx/208xx performance line ordering information scheme(1) on

page 100).

The following example shows how to calculate the temperature range needed for a given

application.

Assuming the following application conditions:

●

Maximum ambient temperature TAmax= 82 °C (measured according to JESD51-2)

●

IDDmax = 15 mA, VDD = 5.5 V

●

Maximum eight standard I/Os used at the same time in output at low level with IOL = 10

mA, VOL= 2 V

●

Maximum four high sink I/Os used at the same time in output at low level with IOL = 20

mA, VOL= 1.5 V

●

Maximum two true open drain I/Os used at the same time in output at low level with

IOL = 20 mA, VOL= 2 V

PINTmax = 15 mA x 5.5 V = 82.5 mW

PIOmax = (10 mA x 2 V x 8 ) + (20 mA x 2 V x 2) + (20 mA x 1.5 V x 4) = 360 mW

This gives: PINTmax = 82.5 mW and PIOmax 360 mW:

PDmax = 82.5 mW + 360 mW

Thus: PDmax = 443 mW

Using the values obtained in Table 57: Thermal characteristics on page 96 TJmax is

calculated as follows for LQFP64 10 x 10 mm = 46 °C/W:

TJmax = 82 °C + (46 °C/W x 443 mW) = 82 °C + 20 °C = 102 °C

This is within the range of the suffix 6 version parts (-40 < TJ < 105 °C).

In this case, parts must be ordered at least with the temperature range suffix 6.

STM8S207MBT3 Fiches technique(PDF) 97 Page - STMicroelectronics