CS4350 datasheet(21/41 Pages) CIRRUS

21 / 41 page

DS691F1

CS4350

4.4

De-Emphasis

The device includes on-chip digital de-emphasis. Figure 16 shows the de-emphasis curve for Fs equal to

44.1 kHz. The frequency response of the de-emphasis curve will scale proportionally with changes in sam-

ple rate, Fs.

Note:

De-emphasis is only available in Single-Speed Mode.

4.5

Mute Control

The mute control pins (AMUTEC and BMUTEC) go active during power-up initialization, reset, muting (see

Section 8.4.3), and loss of LRCK. These pins are intended to be used as control for external mute circuits

to prevent the clicks and pops that can occur in any single-ended single-supply system.

Use of the mute control function is not mandatory but recommended for designs requiring the absolute min-

imum in extraneous clicks and pops. Also, use of the Mute Control function can enable the system designer

to achieve idle-channel noise and signal-to-noise ratios which are only limited by the external mute circuit.

4.6

Recommended Power-Up Sequence

4.6.1

Stand-Alone Mode

1. Hold RST low until the power supplies and configuration pins are stable, and the master and left/right

clocks are fixed to the appropriate frequencies, as discussed in Section 4.2. In this state, the control

port registers are reset to their default settings, VQ will remain low, and VBIAS will be connected to

VA.

2. Bring RST high. The device will remain in a low power state with VQ low for approximately 512 LRCK

cycles in Single-Speed Mode (1024 LRCK cycles in Double-Speed Mode, and 2048 LRCK cycles in

Quad-Speed Mode).

3. The device will then initiate the power up sequence which lasts approximately 50 µs when the

Popguard is disabled. If the Popguard is enabled, see Section 4.7 for a complete description of

power-up timing.

Gain

-10dB

0dB

Frequency

T2 = 15 µs

T1=50 µs

3.183 kHz

10.61 kHz

Figure 16. De-Emphasis Curve

CS4350 Fiches technique(PDF) 21 Page - Cirrus Logic