ST7LNB0

13/22

EMC CHARACTERISTICS (Cont’d)

6.5.3 Absolute Maximum Ratings (Electrical

Sensitivity)

Based on three different tests (ESD, LU and DLU)

using specific measurement methods, the product

is stressed in order to determine its performance in

terms of electrical sensitivity. For more details, re-

fer to the application note AN1181.

6.5.3.1 Electro-Static Discharge (ESD)

Electro-Static Discharges (a positive then a nega-

tive pulse separated by 1 second) are applied to

the pins of each sample according to each pin

combination. The sample size depends on the

number of supply pins in the device (3 parts*(n+1)

supply pin). This test conforms to the JESD22-

A114A/A115A standard.

Absolute Maximum Ratings

Notes:

1. Data based on characterization results, not tested in production.

6.5.3.2 Static and Dynamic Latch-Up

on 10 parts to assess the latch-up performance.

A supply overvoltage (applied to each power

supply pin) and a current injection (applied to

each input, output and configurable I/O pin) are

performed on each sample. This test conforms

to the EIA/JESD 78 IC latch-up standard. For

more details, refer to the application note

AN1181.

then one negative test) are applied to each pin

of 3 samples when the micro is running to

assess the latch-up performance in dynamic

mode. Power supplies are set to the typical

values, the oscillator is connected as near as

possible to the pins of the micro and the

component is put in reset mode. This test

conforms to the IEC1000-4-2 and SAEJ1752/3

standards. For more details, refer to the

application note AN1181.

Electrical Sensitivities

Notes:

1. Class description: A Class is an STMicroelectronics internal specification. All its limits are higher than the JEDEC spec-

ifications, that means when a device belongs to Class A it exceeds the JEDEC standard. B Class strictly covers all the

JEDEC criteria (international standard).

Symbol

Ratings

Conditions

Electro-static discharge voltage

(Human Body Model)

4000

V

Symbol

Parameter

Conditions

LU

Static latch-up class

A

DLU

Dynamic latch-up class

A