DS10473 Rev 2

19/25

STPA003

General information

24

5.3

Protections

5.3.1

Short circuits and open circuit operation

amplifier is put in three-state (high impedance condition). The power stage remains in this

condition until the short is removed.

In case of short circuit to ground or Vcc, the amplifier exits from the three-state condition

only when the output returns inside the limits imposed by an internal voltage comparator.

When a short across the load is present, the power stage sees an over-current and is

brought in protection mode for 100 µs. After this time, if the short circuit condition is removed

the amplifier returns to play, otherwise the high impedance state is maintained and the

check is repeated every 100 µs.

Disconnection of load (open load condition) doesn't damage the amplifier, which continues to play.

5.3.2

Over-voltage and load dump protection

When the battery voltage is higher than 19 V, the amplifier is switched to a high impedance

state. It stops playing till the supply voltage returns in the permitted range.

The amplifier is protected against load dump surges having amplitude as high as 50 V and a

rising time lower than 5 ms (see Figure 25).

Figure 25. Load dump protection diagram

5.3.3

Thermal protection

output power and limit power dissipation. If this is not enough and the junction temperature

continues to increase, the amplifier is switched off when reaches the maximum temperature

of 170 °C.

Figure 26. Thermal protection diagram

50V Vdump

14.4V Vcc

< 5ms

50ms

GAPGPS00710

Junction temperature ( C)

150 C

170 C

GAPGPS00711