GLS53 datasheet(49/109 Pages) EMERSON-NETWORKPOWER

49 / 109 page

GLS354-C, GLS355-C, GLS355-CEF Installation & Operating Instructions

P/N: A272-172 Rev 2 01/06/10 Ref: LPS354&355\OP.K

Installation & Safety

To comply with the published safety standards, the following must be observed when

using this power supply:

1. Maximum ambient temperature for the power supply must not exceed 50°C.

2. When installing the power supply in the end-use equipment, special attention

is required to ensure safety compliance with the following safety standards:

UL60950-1, EN60950-1, IEC60950-1, and CSA22.2 No. 60950-1-03; including the

requirements for creepage distances, clearances, and distance through insulation

between primary wiring and earth or secondary (SELV) wiring.

3. The power supply’s rated input voltage is automatically selected. Please refer to

the specification sheet for the input voltage range.

4. The maximum output power of the supply must not exceed the rating indicated in

the specification sheet.

5. This unit contains a secondary output exceeding 240 VA. When installing the unit

into the end system, make sure the secondary output and the appropriate wire

cannot be touched.

6. Hazardous voltages exist in the primary circuits. Disconnect the power supply

before servicing.

7. The internal fuse should only be replaced with a F10AH, 250 V ac, type

SP0001.1014 manufactured by Schurter AG or type 216010 manufactured by

Littelfuse.

8. This power supply is

marked following the provisions of the Low Voltage

Directive, 2006/95/EC.

For technical assistance, contact SolaHD Technical Support at (800) 377-4384 or

send an e-mail to tech@solahd.com. Please visit our Web site at www.solahd.com for

additional product information and specification sheets.

Output Ratings

Model

OutputVoltage(V)

30CFMForcedAirCooling(unit not convection rated)

Max.OutputCurrent(A) Max.OutputPower(W)

GLS354-C

15 (+12 to +24)

23.4

350 with cover

GLS355-C(-CEF)

24 (+24 to +48)

14.6

Mechanical Outline

Output Voltage

Adjust Trimmer

SK1

SK4

SK5

SK6

SK3

TB1

+V out

Common

Connector PIN Designation

InputConnector

Designation

SK1

Neutral

Line

Earth GND

OutputConnector

Designation

TB1

V1 positive

V1 common

SK3

No connection

+Sense

-Sense

P OK

C. Share

Dc OK

Inhibit (normally open)

Inhibit (normally closed)

Common

SK4

+5 V (aux)

Common

SK5

+Fan 1 (+12 V)

Common

SK6

+Fan 2 (+12 V)

Common

GLS53 Fiches technique(PDF) 49 Page - Emerson Network Power

GLS53 Fiches technique(HTML) 49 Page - Emerson Network Power

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Fiches technique Télécharger

Lien URL