LTM8003 datasheet(15/28 Pages) AD

15 / 28 page

LTM8051

Rev. 0

For more information www.analog.com

For most applications, the design process is straight-

forward, summarized as follows:

1. Look at Table 1 and find the row that has the desired

input range and output voltage.

2. Apply the recommended CIN, COUT, RFB and RT values.

3. Connect BIAS as indicated.

When using the LTM8051 with different output voltages,

the higher frequency recommended by Table 1 will usu-

ally result in the best operation. While these component

combinations have been tested for proper operation, it is

incumbent upon the user to verify proper operation over

the intended system’s line, load and environmental condi-

tions. Bear in mind that the maximum output current is

limited by junction temperature, the relationship between

the input and output voltage magnitude and other fac-

tors. Please refer to the graphs in the Typical Performance

Characteristics section for guidance.

The maximum frequency (and attendant RT value) at

which the LTM8051 should be allowed to switch is given

in Table 1 in the Maximum fSW column, while the recom-

mended frequency (and RT value) for optimal efficiency

over the given input condition is given in the fSW column.

There are additional conditions that must be satisfied if

the synchronization function is used. Please refer to the

Synchronization section for details.

APPLICATIONS INFORMATION

Set Output Voltage

The output voltage is programmed with a FB resistor as

shown in the Figure below. Choose the resistor value

according to:

RFB =

249kΩ

VOUT

0.8V

−1

1% resistor is recommended to maintain output voltage

accuracy.

249k

10pF

3.3nF

2.2µH

RFB

CURRENT MODE

CONTROLLER

0.8V

VOUT

–

8051 F01

Figure 1. Set Output Voltage with a FB Resistor

LTM8003 Fiches technique(PDF) 15 Page - Analog Devices

LTM8003 Fiches technique(HTML) 15 Page - Analog Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Fiches technique Télécharger

Lien URL