ATSAM3103 datasheet(7/24 Pages) ATMEL

7 / 24 page

ATSAM3103

6093A–DRMSD–25-Oct-04

Pinout

Pin Description

•

Identical sharing number indicates multifunction pins.

•

Pd indicates a pin with built-in pull-down resistor.

•

Pu indicates a pin with built-in pull-up resistor.

Table 2. Pinout by Pin Name

Pin Name

Pin Number

Type

Sharing Description

GND

4, 13, 19, 25 , 36, 43,

48, 57

PWR

Digital ground. All these pins should be returned to a ground plane

VC18

12, 31, 46, 63

PWR

Core power. All these pins should be returned to nominal 1.8V or to

PWROUT if the built-in power switch is used.

VC33

3, 32

PWR

Periphery power. All these pins should be returned to nominal 3.3V.

PWRIN

PWR

Power switch input; should be returned to nominal 1.8V even if the power

switch is not used

PWROUT

PWR

Power switch output; should be connected to all VC18 pins if the power

switch is used

D7 - D0

59, 58, 56, 55, 52, 51,

50, 49

I/O

Slave 8-bit interface data. Output if CS and RD are low (read from chip),

input if CS and WR are low (write to chip). Type of data defined by A0 input.

I/O7 - I/O0

59, 58, 56, 55, 52, 51,

50, 49

I/O

SmartMedia data or other peripheral data

P0.7 - P0.0

59, 58, 56, 55, 52, 51,

50, 49

I/O

General-purpose I/O; can be programmed individually as input or output

CLAD3 - 0

59, 58, 56, 55

Optional bit clocks for digital audio input. Used for sampling rate

conversion, for external incoming digital audio such as AES/BEU or

S/Pdif.

WSAD3 - 0

52, 51, 50, 49

Optional word selects for digital audio input. Used for sampling rate

conversion, for external incoming digital audio such as AES/BEU or

S/Pdif.

Slave 8-bit interface address. Indicates data/status or data/ctrl transfer

type (CS RD low or CS WR low)

SMPD

SmartMedia presence detect

P0.10

General-purpose input pin

SCLK

Serial slave synchronous interface input clock

Slave 8-bit interface chip select, active low

P0.11

General-purpose input pin

SYNC

Serial slave synchronous interface input sync signal

Slave 8-bit interface write, active low. D7 - D0 data is sampled by chip on

WR rising edge if CS is low

SMC

SmartMedia configuration. This pin is sensed after power-up. If found low,

it is assumed that a SmartMedia connector is present. The built-in

firmware will wait for SmartMedia SMPD.

P0.12

General-purpose input pin

Slave 8-bit interface read, active low. D7 - D0 data is output when RD

goes low and CS is low

ATSAM3103 Fiches technique(PDF) 7 Page - ATMEL Corporation

ATSAM3103 Fiches technique(HTML) 7 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Fiches technique Télécharger

Lien URL