MP3276

9

Rev. 4.00

Figure 3. Load Circuit for Data

Access Time Test

3k

3k

+5 V

Figure 4. Load Circuit for

Bus Relinquish Time Test

3k

10pF

3k

10pF

+5 V

N

DB

N

DB

N

DB

Figure 5. Load Circuit for WR to STS Delay

DGND

STL, STS

Serial Data Output Mode (PXS = 0)

The MP3276 output data is available in serial form when PXS

= 0 prior to the RD high-to-low transition. When PXS = 0, the

DB11/SDO pin functions as the serial data output.

The

DB0/SDC pin functions as the serial clock input and all other

data outputs are 3-stated.

The serial data output sequence is MSB (DB11) first to LSB

(DB0) last. The MSB (DB11) data bit appears at DB11/SDO

when STS goes low. The second most significant bit appears at

DB11/SDO on the next DB0/SDC high-to-low transition. The

LSB (DB0) is present at DB11/SDO on the 11th SDC high-to-low

transition.

The control pin functions (ADEN, CS, WR, and RD) are the

same as the parallel mode of operation. Further information re-

garding serial control and timing is shown in

Figure 6., Table 4.

and

Table 5.

For a minimum interconnect serial environment, the channel

address state can be generated in at least two ways, using an

address counter, or using an address serial to parallel converter.

WR can then be used as the counter clock or shift register load

signal as well as the A/D converter start convert signal on the ris-

ing edge. (Note that the falling edge loads the address present at

the address port.)

SDC

DB11/SDO

Figure 6. Serial Data Mode Timing

DB11 (MSB)

DB10

assumed that PXS is hardwired low. However, if the mode of operation is changed, PXS must go low prior to RD going low.

STS

See Table 4