PI5C6800LE datasheet(2/5 Pages) PERICOM

2 / 5 page

PS8194E

09/13/04

PI5C6800

10-Bit Bus Switch with

Precharged Outputs

Storage Temperature .....................................................–65°C to +150°C

Supply Voltage Range.........................................................–0.5V to +7V

DC Input Voltage(2).............................................................–0.5V to +7V

Input Clamp Current, IIK (V1<0)..................................................–50mA

DC Output Current........................................................................120mA

Power Dissipation(3) ........................................................................0.5W

Notes:

Stresses greater than those listed under MAXIMUM RATINGS may cause permanent damage to the device. This is a stress rating only and

functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not

implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.

The input and output negative-voltage ratings may be exceeded if the input and output clamp-current ratings are observed.

The maximum package power dissipation is calculated using a junction temperatue of 150°C and a board trace length of 750 mils.

Absolute Maximum Ratings Over Free-Air Temperature Range(1)

(Above which the useful life may be impaired. For user guidelines, not tested.)

Recommended Operating Conditions

Parameters

Description

Min.

Typ.

Units

VCC

Supply Voltage

5.5

BIASV

Supply Voltage

1.3

VCC

VIH

High-level input voltage

VIL

Low-level input voltage

0.8

Operating free-air voltage

-40

°C

Electrical Characteristics (Over Recommended Operating Free-air Temperature Range)

Parameters

Test Condidtion

Min.

Typ.(3)

Max.

Units

VIK

VCC = 4.5V, II = -18mA

-1.2

VCC = 5.5V, VI = 5.5V or GND

±5

µA

VCC = 4.5V, BIASV = 2.4V, VO = 0

-0.20

ICC

VCC = 5.5V, IO = 0, VI = VCC or GND

µA

∆ICC(2)

VCC = 3.6V, One input at 2.7V Other at VCC or GND

2.5

CIN

VI = 3V or 0

3.5

COFF

VO = 3V or 0, Switch Off

4.5

RON(1)

VCC = 4V

VI = 2.4V, II = 15mA

Ω

VCC = 4.5V

VI = 0V, II = 64mA

VI = 0V, II = 30mA

VI = 2.4V, II = 15mA

Notes:

1. Measured by the voltage drop between the A and B terminals at the indicated current through the switch. On-State resistance is determined by

the lower of the voltages of the two (A or B) terminals.

2. This is the increase in supply current for control input.

3. All typical values are at VCC = 5V, TA = 25°C.

PI5C6800LE Fiches technique(PDF) 2 Page - Pericom Semiconductor Corporation

PI5C6800LE Fiches technique(HTML) 2 Page - Pericom Semiconductor Corporation

Html Pages

1 2 3 4 5

Fiches technique Télécharger

Lien URL