USB5742-SLASH2G datasheet(15/46 Pages) MICROCHIP

15 / 46 page

 2015-2016 Microchip Technology Inc.

DS00002016B-page 15

USB5742

3.4

Configuration Straps and Programmable Functions

Configuration straps are multi-function pins that are used during Power-On Reset (POR) or external chip reset

(RESET_N) to determine the default configuration of a particular feature. The state of the signal is latched following de-

assertion of the reset. Configuration straps are identified by an underlined symbol name. This section details the various

device configuration straps and associated programmable pin functions.

3.4.1

SPI/SMBUS CONFIGURATION

The SPI/SMBus pins can be configured into one of two functional modes:

• SPI Mode

• SMBus Slave Mode

If 10 k

 pull-up resistors are detected on SPI_DO and SPI_CLK, the SPI/SMBus pins are configured into SMBus Slave

Mode. If no pull-ups or pull-downs are detected on SPI_DO and SPI_CLK, the SPI/SMBus pins are first configured into

SPI Mode. The strap settings for these supported modes are detailed in Table 3-9. The individual pin function assign-

ments for each mode are detailed in Table 3-10. For additional device connection information, refer to Section 4.0,

"Device Connections".

Note 4:

In order to use the SPI interface, an SPI ROM containing a valid signature of 2DFU (device firmware

upgrade) beginning at address 0xFFFA must be present. Refer to Section 7.1, "SPI Master Interface" for

additional information.

Note:

The system designer must guarantee that configuration straps meet the timing requirements specified in

Section 9.6.2, "Power-On and Configuration Strap Timing," on page 33 and Section 9.6.3, "Reset and Con-

figuration Strap Timing," on page 34. If configuration straps are not at the correct voltage level prior to being

latched, the device may capture incorrect strap values.

TABLE 3-9:

SPI/SMBUS MODE CONFIGURATION SETTINGS

SPI Mode

(Note 4)

SMBus Slave Mode

(SPI_DO)

No pull-up/down

10 k

 pull-up

(SPI_CLK)

No pull-up/down

10 k

 pull-up

TABLE 3-10:

SPI/SMBUS MODE PIN ASSIGNMENTS

SPI Mode

SMBus Slave Mode

SPI_CE_N

CFG_NON_REM

SPI_DI

CFG_BC_EN

SPI_DO

SMDAT

SPI_CLK

SMCLK

USB5742-/2G Fiches technique(PDF) 15 Page - Microchip Technology

USB5742-/2G Fiches technique(HTML) 15 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46

Fiches technique Télécharger

Lien URL