ML2724

LVLO - Register 0, Bit 10

Low Voltage Lock Out:

The LVLO bit enables a transmit low voltage lockout latch, which shuts off the transmitter by

de-asserting the PAON output. This latch is set if the supply voltage drops below 2.65V and is reset when the RXON

control input goes high (see Table 12).

LVLO

PAON BEHAVIOR

0

PAON Undisturbed

1

PAON de-asserted when VCCA<2.65V,

Reset by RXON high.

Table 12: LVLO Operation

RCLP - Register 0, Bit 11

RSSI Clip Enable:

The RCLP bit disables the RSSI clipping circuitry. With RCLP low, the RSSI output voltage is

clipped to a maximum of about 2.0V at –10dBm. With RCLP high, the RSSI is not clipped. (see Table 13).

RCLP

RSSI BEHAVIOR

0

RSSI output clipped to a maximum of ~1.9V at –15dBm

1

RSSI output not clipped

Table 13: RCLP Operation

CHQ <11:0> - Register 1, Bits 2-13

Channel Frequency Selection:

These bits set the RF carrier frequency for the transceiver (see Table 14). With a

6.144MHz or 12.288MHz clock at the FREF pin, the channel frequency value is calculated by multiplying the CHQ value

by 1.024.

The recommended operating range value of the CHQ is from 2,346 to 2,424. These bits must be

programmed to a valid channel frequency before XCEN is asserted.

B15

B14

B13 TO B2

B1

B0

0

0

CHQ - PLL Divide Ratio

0

1

Table 14: Main Divider

The divide ratio is calculated as f

C

/1.024 where f

C

is the channel frequency in MHz.

DS2724-F-01

FINAL DATASHEET

APRIL 2003

21