| Moteur de recherche de fiches techniques de composants électroniques |
|
SAA6752HS/V103 Fiches technique(PDF) 34 Page - NXP Semiconductors |
|
|
|||||||||||||||||||||||||||||
SAA6752HS/V103 Fiches technique(HTML) 34 Page - NXP Semiconductors |
|
34 / 71 page ![]() 2004 Jan 26 34 Philips Semiconductors Product specification MPEG-2 video and MPEG-audio/AC-3 audio encoder with multiplexer SAA6752HS 7.9 Clock generation 7.9.1 GENERAL The SAA6752HS is designed to operate with a single fundamental 27 MHz crystal or an external 27 MHz clock. From these clock sources an internal PLL produces the 27 MHz, 54 MHz and 108 MHz frequencies needed for operation. It is possible to use a third overtone crystal in combination with a 9 MHz external trap. In this event Clock mode 2 and tuning by the I2C-bus commands are not usable. 7.9.2 CLOCK CONFIGURATION OPTIONS The following configuration options can be selected from the host: • CLOCK MODE. Dependent on the type of application (i.e. video frame locked, reference clock locked etc.), three different clock modes are available • CLOCK SOURCE. The clock can be generated from an internal crystal controlled clock or an external source. If from a crystal then a fine tune adjustment is available • CLOCK OUTPUT. It is possible to enable a system clock output so that the 27 MHz clock can be used elsewhere by the user. 7.9.3 CLOCK MODES The SAA6752HS internal PLL can be configured in three different clock modes: Clock modes 1, 2 and 3. A definition of the clock modes is shown in Table 9. The clock modes are intended for different applications: • Clock mode 1. System clock reference locked to input video frame frequency. Intended for applications where the output stream is recorded directly onto a medium (i.e. DVD video recorder). • Clock mode 2. Crystal locked to input video frame frequency. Intended for applications that require both recording and direct playback. However it is limited by the required accuracy of the input video frame frequency • Clock mode 3. Crystal free-running. Intended for applications where the output stream is played real time directly by a decoder. To meet the requirements for each clock mode the conditions specified in Table 10 must be met. Table 9 Clock modes Note 1. The stream contents are MPEG-compliant but the time stamps are not synchronized with real time (i.e. dependent on the accuracy of the video input frame frequency). Playback of such a stream is MPEG-compliant due to the re-generation of time synchronization. Table 10 Clock modes requirements Note 1. The nominal video frame frequency is dependent on the video mode set: 525 or 625 lines. CLOCK MODE OUTPUT STREAM TIME-STAMP COMPLIANCE SYSTEM FREQUENCY SYSTEM CLOCK REFERENCE FREQUENCY 1 DVD-compliant(1) crystal frequency 27 MHz ± video frame frequency accuracy 2 DVD and MPEG-compliant 27 MHz ± video frame frequency accuracy 27 MHz ± video frame frequency accuracy 3 MPEG-compliant crystal frequency crystal frequency CLOCK MODE CRYSTAL FREQUENCY EXTERNAL CLOCK FREQUENCY INPUT VIDEO FRAME FREQUENCY(1) 1 27 MHz ±0.1% 27 MHz ±0.1% nominal − 8% to nominal + 2% 227 × (1 ±200 × 10−6) MHz (to allow fine tuning via PLL) not applicable nominal × (1 ±200 × 10−6) 327 × (1 ±30 × 10−6) MHz 27 × (1 ±30 × 10−6) MHz not applicable |
|
Lien URL |
| ALLDATASHEET vous a-t-il été utile ? [ DONATE ] |
À propos de Alldatasheet | Publicité | Contactez-nous | Politique de confidentialité | Lien vers la fiche technique | Echange de liens | Fabricants All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |