HT-10-2 datasheet(4/5 Pages) HIROSE

4 / 5 page

sMounting Method

qDo not leave a space between the terminator and

the microstrip board.

qMake the terminator tab height from the housing and

the thickness of the microstrip board the same

amount.

qNote: The HT-025-1 type is attached with high

temperature solder (having a melting point of 280ç).

The soldering temperature to the microstrip board

must be less than this.

qMounting is performed by soldering over the

microstrip line pattern.

qThe mounting should be completed by soldering

within 5 seconds using Sn-Pb type eutectic solder

containing 2 to 5% Ag with a soldering iron adjusted

to about 260ç.

qThe resoldering of an item that has already been

soldered once and then removed is not effective

since solder cracks will develop at the electrode

portion.

qDo not leave a space between the terminator and

the microstrip board.

qDo not leave a space between the the microstrip

board.

qNote: The HT-1-1, HT-1-2, HT-1-3, HT-10-2, HT-20-

3, and HT-50-1 tabs are attached with high

temperature solder (having a melting point of 280ç).

The soldering temperature to the microstrip board

must be less than this.

Note: Although the high frequency characteristics will

deteriorate somewhat, please attach with some slack

in the tabs in order to raise the thermal reliability.

HT-025-1

HT-05-2

HT-1-1, HT-1-2, HT-1-3, HT-10-2,

HT-20-3, HT-30-1, HT-50-1

HT-10-2 Fiches technique(PDF) 4 Page - Hirose Electric