SP6134HCUSLASHTR datasheet(11/14 Pages) SIPEX

11 / 14 page

Date: 8/4/04

SP6134H High Voltage, 600KHz Synchronous PWM Controller

layout, as well as device package. Significant

thermal improvement can be achieved in the maxi-

mum power dissipation through the proper design

of copper mounting pads on the circuit board. For

example, in a SO-8 package, placing two 0.04

square inches copper pad directly under the pack-

age, without occupying additional board space,

can increase the maximum power from approxi-

mately 1 to 1.2W. For DPAK package, enlarging

the tap mounting pad to 1 square inches reduces the

RΘJA from 96°C/W to 40°C/W.

APPLICATIONS INFORMATION: Continued

Schottky Diode Selection

When paralleled with the bottom MOSFET, an

optional Schottky diode can improve efficiency

and reduce noises. Without this Schottky diode,

the body diode of the bottom MOSFET con-

ducts the current during the non-overlap time

when both MOSFETs are turned off. Unfortu-

nately, the body diode has high forward voltage

and reverse recovery problem. The reverse re-

covery of the body diode causes additional

switching noises when the diode turns off. The

Schottky diode alleviates these noises and addi-

tionally improves efficiency thanks to its low

forward voltage. The reverse voltage across the

diode is equal to input voltage, and the diode

must be able to handle the peak current equal to

the maximum load current.

The power dissipation of the Schottky diode is

determined by

PDIODE = 2VFIOUTTNOLFS

where

TNOL = non-overlap time between GH and GL.

VF = forward voltage of the Schottky diode.

Loop Compensation Design

The open loop gain of the whole system can be

divided into the gain of the error amplifier,

PWM modulator, buck converter output stage,

and feedback resistor divider. In order to cross-

over at the selected frequency FCO, the gain of

the error amplifier has to compensate for the

attenuation caused by the rest of the loop at this

frequency.

(SRz2Cz2+1)(SR1Cz3+1)

(SRESRCOUT+ 1)

[S^2LC

OUT+S(RESR+RDC) COUT+1]

VIN

SR1Cz2(SRz3Cz3+1)(SRz2Cp1+1)

VRAMP_PP

VOUT

(Volts)

VREF

(Volts)

Notes: R

ESR = Output Capacitor Equivalent Series Resistance.

DC = Output Inductor DC Resistance.

RAMP_PP = SP6132 Internal RAMP Amplitude Peak to Peak Voltage.

Condition: Cz2 >> Cp1 & R1 >> Rz3

Output Load Resistance >> R

ESR & RDC

VREF

(R1 + R2)

VOUT

VFBK

(Volts)

Type III Voltage Loop

Compensation

AMP (s) Gain Block

PWM Stage

PWM Gain

Block

Output Stage

OUT (s) Gain

Block

Voltage Feedback

FBK Gain Block

SP6134H Voltage Mode Control Loop with Loop

Dynamic

SP6134HCU/TR Fiches technique(PDF) 11 Page - Sipex Corporation

SP6134HCU/TR Fiches technique(HTML) 11 Page - Sipex Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Fiches technique Télécharger

Lien URL