CAP1133 datasheet(43/63 Pages) MICROCHIP

43 / 63 page

 2015 Microchip Technology Inc.

DS00001625B-page 43

CAP1133

APPLICATION NOTE: The PWM frequency is determined based on the selected LED behavior, the programmed

breathe period, and the programmed min and max duty cycles. For the Direct behavior

mode, the PWM frequency is calculated based on the programmed Rise and Fall times. If

these are set at 0, then the maximum PWM frequency will be used based on the

programmed duty cycle settings.

6.32

LED Pulse 1 Period Register

The LED Pulse Period 1 register determines the overall period of a pulse operation as determined by the LED_CTL

registers (see Table 6-52 - setting 01b). The LSB represents 32ms so that a setting of 18h (24d) would represent a

period of 768ms (24 x 32ms = 768ms). The total range is from 32ms to 4.064 seconds as shown in Table 6-54 with the

default being 1024ms.

APPLICATION NOTE: Due to constraints on the LED Drive PWM operation, any Breathe Period less than 160ms

(05h) may not be achievable. The device will breathe at the minimum period possible as

determined by the period and min / max duty cycle settings.

Bit 7 - ST_TRIG - Determines the start trigger for the LED Pulse behavior.

• ‘0’ (default) - The LED will Pulse when a touch is detected or the drive bit is set.

• ‘1’ - The LED will Pulse when a release is detected or the drive bit is cleared.

The Pulse 1 operation is shown in Figure 6-1 when the LED output is configured for non-inverted polarity (LEDx_POL

= 1) and in Figure 6-2 for inverted polarity (LEDx_POL = 0).

Breathe

The LED will breathe. It will be driven with a

duty cycle that ramps up from the pro-

grammed minimum duty cycle (default 0%) to

the programmed maximum duty cycle duty

cycle (default 100%) and then back down.

Each ramp takes up 50% of the programmed

period. The total period of each “breath” is

determined by the LED Breathe Period con-

trols - see Section 6.34.

Touch Detected or

LED Output Con-

trol bit set

Release

Detected or

LED Output

Control bit

cleared

TABLE 6-53:

LED PULSE 1 PERIOD REGISTER

ADDR

R/W

Default

84h

R/W

LED Pulse 1

Period

ST_

TRIG

P1_

PER6

P1_

PER5

P1_

PER4

P1_

PER3

P1_

PER2

P1_

PER1

P1_

PER0

20h

TABLE 6-52:

LEDX_CTL BIT DECODE (CONTINUED)

LEDx_CTL

[1:0]

Operation

Description

Start TRigger

Stop Trigger

CAP1133 Fiches technique(PDF) 43 Page - Microchip Technology

CAP1133 Fiches technique(HTML) 43 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63

Fiches technique Télécharger

Lien URL