RS5-R30-RD30 datasheet(3/4 Pages) RSG

3 / 4 page

INPUT REFLECTED RIPPLE CURRENT TEST STEP

Input Reflected Ripple Current is measured through a

source inductor Lin (12 uH) and a source capacitor

Cin (47 uF, ESR < 1.0 M at 100 kHz) at nominal input and

full load.

OUTPUT RIPPLE & NOISE MEASUREMENT TEST

The Scope measurement bandwidth is 20 MHz.

EFFICIENCY VS OUTPUT CURRENT 05

05 MODELS

EFFICIENCY VS OUTPUT CURRENT 12

12 MODELS

EFFICIENCY VS OUTPUT CURRENT 24

24 MODELS

TEST CONFIGURATIONS

EMI Filter

Input filter components (C1, L) are used to help meet

conducted emissions requirement for the module. These

components should be mounted as close as possible to the

module; and all leads should be minimized to decrease

radiated noise.

Page: 3/4

Last update: 30.01.09

EFFICIENCY VS OUTPUT CURRENT 48

48 MODELS

RS5-05XXXXX

RS5-12XXXXX

RS5-24XXXXX

RS5-48XXXXX

The models listed are just for standard type. If you need a

special specification product, please contact our service.

Phone: +49 69 984047-0, mail to: info@rsg-electronic.de

or use the forms on www.rsg-electronic.de („Kontakt“).

RS5-R30/RD30

3.0 Watt 2:1 regulated

single & dual output

RS5-R30-RD30 Fiches technique(PDF) 3 Page - RSG Electronic Components GmbH