PS219B3-S, PS219B3-AS, PS219B3-CS

Intellimod™ Module

Dual-In-Line Intelligent Power Module

10 Amperes/600 Volts

9

12/11 Rev. 0

Powerex, Inc., 173 Pavilion Lane,Youngwood, Pennsylvania 15697-1800 (724) 925-7272 www.pwrx.com

Protection Function Timing Diagrams

A1

A4

A5

A2

SC

A7

A3

SET

RESET

RC CIRCUIT TIME CONTAINS

DELAY

SC REFERENCE VOLTAGE

A6

A8

N-SIDE

CONTROL INPUT

PROTECTION

CIRCUIT STATE

INTERNAL IGBT GATE

OUTPUT CURRENT IC

SENSE VOLTAGE OF

THE SHUNT RESISTOR

FAULT OUTPUT FO

Short-Circuit Protection (N-side only with the external shunt resistor and RC filter)

B1

B4

B5

B2

UVDt

B7

B3

SET

RESET

RESET

UVDr

B6

N-SIDE CONTROL INPUT

PROTECTION

CIRCUIT STATE

CONTROL SUPPLY

VOLTAGE VD

OUTPUT CURRENT IC

FAULT OUTPUT FO

Under-Voltage Protection (N-side, UVD)

A1: Normal operation – IGBT turn on and conducting current.

A2: Short-circuit current detected (SC trigger).

A3: All N-side IGBT gate hard interrupted.

A4: All N-side IGBTs turn off.

A5: FO output with a fixed pulse width of tFO(min) = 20µs.

A6: Input “L” – IGBT off.

A7: Input “H” – IGBT off in spite of “H” input.

A8: Normal operation – IGBT on and conducting current.

B1: Control supply voltage rise – After the voltage level reaches UVDr, the drive circuit begins to work

at the rising edge of the next input signal.

B2 : Normal operation – IGBT turn on and conducting current.

B3: Under-voltage trip (UVDt).

B4: All N-side IGBTs turn off regardless of the control input level.

B5: FO output during under-voltage period, however, the minimum pulse width is 20µs.

B6: Under-voltage reset (UVDr).

B7: Normal operation – IGBT turn on and conducting current.