NEW PRODUC T BULLE TIN 601

Pleasevisitwww.switchcraft.comforthemostup-to-dateproductspecifications.MadeinUSA.

0.375

9.5

MAX

0.188±0.015

4.8±0.4

Feed the free end of cable through the handle, cable-clamp/grommet, and coupling ring

in the order shown.

Strip cable end and conductors as shown.

Soldering or crimping conductors to contacts is recommended before insertion into connector.

If crimping, use hand or pneumatic crimp tool with crimp positioner per contact size.

If soldering after contacts are inserted in the connector, limit exposure of contacts to soldering iron

temperature to 4 sec. maximum. Soldering iron temperature should not exceed 650°F (343°C).

Insert wired contacts into connector housing using an insertion tool and per contacts arrangements.

Align coupling ring over housing and bring forward.

Align cable-clamp/grommet on the rear of housing. Make certain grommet is completely inside

the cable-clamp in the nal position.

Bring forward and thread handle onto housing until tight. Do not exceed 2 in-lb torque.

EN2 CORD CONNECTOR FIELD ASSEMBLY INSTRUCTIONS: