SSL4101T datasheet(14/29 Pages) NXP

14 / 29 page

SSL4101T

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 1 — 21 April 2011

14 of 29

NXP Semiconductors

SSL4101T

GreenChip III+ SMPS control IC

The driver output is latched in the logic, preventing multiple switch-on.

7.3.4 Demagnetization (FBAUX pin)

The system is always in quasi-resonant or discontinuous conduction mode. The internal

oscillator does not start a new primary stroke until the previous secondary stroke has

ended.

Demagnetization features a cycle-by-cycle output short circuit protection by immediately

lowering the frequency (longer off-time), thereby reducing the power level.

Demagnetization recognition is suppressed during the first tsup(xfmr_ring) time (2 μs typical).

This suppression may be necessary at low output voltages and at start-up and in

applications where the transformer has a large leakage inductance.

If pin FBAUX is open circuit or not connected, a fault condition is assumed and the

converter stops operating immediately. Operation restarts as soon as the fault condition is

removed.

7.3.5 Flyback control/time-out (FBCTRL pin)

The pin FBCTRL is connected to an internal voltage source of 3.5 V via an internal

resistor (typical resistance is 3 k

Ω). As soon as the voltage on this pin is above

2.5 V (typical), this connection is disabled. Above 2.5 V the pin is biased with a small

current. When the voltage on this pin rises above 4.5 V (typical), a fault is assumed and

switching is inhibited. In the SSL4101T, a restart will then be made.

When a small capacitor is connected to this pin, a time-out function can be created to

protect against an open control loop situation. (see Figure 10 and Figure 11) The time-out

function can be disabled by connecting a resistor (100 k

Ω) to ground on the FBCTRL pin.

If the pin is shorted to ground, switching of the flyback controller is inhibited.

In normal operating conditions, when the converter is regulating the output voltage, the

voltage on the FBCTRL pin is between 1.4 V and 2.0 V (typical values) from minimum to

maximum output power.

Fig 9.

Peak current control of flyback part

Vsense(fb)max

(V)

VFBCTRL (V)

1.5 V

2.0 V

0.52 V

flyback

frequency

reduction

PFC off

FBSENSE peak voltage

014aaa160

PFC on

flyback

discontinuous

or QR

flyback

cycle skip

mode

1.4 V

0.13 V

SSL4101T Fiches technique(PDF) 14 Page - NXP Semiconductors

SSL4101T Fiches technique(HTML) 14 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29

Fiches technique Télécharger

Lien URL