TOP233P datasheet(34/36 Pages) POWERINT

34 / 36 page

TOP232-234

7/01

PI-2560-033001

Notes:

1. Controlling dimensions are inches. Millimeter

dimensions are shown in parentheses.

2. Pin locations start with Pin 1, and continue

from left to right when viewed from the front.

Pins 2 and 6 are omitted.

3. Dimensions do not include mold flash or

other protrusions. Mold flash or protrusions

shall not exceed .006 (.15mm) on any side.

4. Minimum metal to metal spacing at the pack-

age body for omitted pin locations is .068

inch (1.73 mm).

5. Position of the formed leads to be measured

at the mounting plane, .670 inch (17.02 mm)

below the hole center.

6. All terminals are solder plated.

Y07B

PIN 1

PIN 7

MOUNTING HOLE PATTERN

.050 (1.27)

.150 (3.81)

.050 (1.27)

.150 (3.81)

.050 (1.27)

.180 (4.58)

.200 (5.08)

PIN 1

.010 (.25) M

.467 (11.86)

.487 (12.37)

.400 (10.16)

.415 (10.54)

.146 (3.71)

.156 (3.96)

.860 (21.84)

.880 (22.35)

.028 (.71)

.032 (.81)

.050 (1.27) BSC

.150 (3.81) BSC

.108 (2.74) REF

PIN 1 & 7

° TYP.

PIN 4

.040 (1.02)

.060 (1.52)

.190 (4.83)

.210 (5.33)

.015 (.38)

.020 (.51)

.095 (2.41)

.115 (2.92)

.236 (5.99)

.260 (6.60)

.165 (4.19)

.185 (4.70)

.040 (1.02)

.060 (1.52)

.045 (1.14)

.055 (1.40)

.670 (17.02)

REF.

.570 (14.48)

REF.

TO-220-7B

TOP233P Fiches technique(PDF) 34 Page - Power Integrations, Inc.

TOP233P Fiches technique(HTML) 34 Page - Power Integrations, Inc.

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

Fiches technique Télécharger

Lien URL