208

Sealed Snap Action Switch

D2VW

Specifications

■ Characteristics

Note: 1. Data shown are of initial value.

2. The dielectric strength shown is measured using a separator between the switch and metal mounting plate.

3. For the pin plunger models, the above values apply for use at the free position and total travel position. For the lever models, the values

apply at the total travel position.

4. The operating temperature of the lead wire (AV0.75f) for non-UL/CSA molded lead wire models is between -40 to 85

°C.

D2VW-5

D2VW-01

Note: 1. The resistive load ratings apply under the following test conditions:

Ambient Temperature = 20

±2°C, Ambient Humidity = 65±5%, Operating frequency = 30 operations/min.

2. The above current ratings are the values of the steady-state current.

3. Inductive load has a power factor of 0.7 min. (AC) and a time constant of 7 ms max. (DC).

4. Lamp load has an inrush current of 10 times the steady-state current.

5. Rating for UL/CSA approval is as follows (See “Approved Standards” section):

Model

D2VW-01

D2VW-5

Operating speed

0.1 mm to 1 m/s (at pin plunger)

Operating frequency

Mechanical: 300 operations/minute max.

Electrical: 30 operations/minute max.

Insulation resistance

100 M

Ω min. (at 500 VDC)

Contact resistance

50 m

Ω max. (100 mΩ max. for molded lead wire models)

Dielectric strength (See note 2)

1,000 VAC, 50/60 Hz for 1 min. between terminals of the same polarity

1,500 VAC, 50/60 Hz for 1 min. between each current-carrying metal parts and ground, and

between each terminal and non-current-carrying metal parts.

Vibration resistance (See note 3)

Malfunction: 10 to 55 Hz, 1.5 mm double amplitude

Shock resistance (See note 3)

Degree of protection

IEC IP67 (excluding the terminals on terminal models).

Degree of protection against electric shock

Class I

Proof tracking index (PTI)

175

Ambient operating temperature

-40

° to 85°C (at 60% RH max.) with no icing

Ambient operating humidity

95% max. (for 5

°C to 35°C)

Life expectancy

Mechanical

10,000,000 operations min. at 60 operations per minute

Electrical

1,000,000 operations min. at 30 ops. per minute. 100,000 operations min. at 30 ops. per minute

Weight

Approx. 7g (pin plunger models without wires)

Rated Voltage

Non-inductive load

Inductive load

Resistive load

Lamp load

Inductive load

Motor load

NC

NO

NC

NO

NC

NO

NC

NO

125 VAC

5 A

0.5 A

4 A

—

250 VAC

5 A

0.5 A

4 A

—

30 VDC

5 A3 A4 A—

125 VDC

0.4 A

0.1 A

0.4 A

—

Rated Voltage

Non-inductive load

Inductive load

Resistive load

Lamp load

Inductive load

Motor load

NC

NO

NC

NO

NC

NO

NC

NO

125 VAC

0.1 A

—

—

—

30 VDC

0.1 A

—

—

—

D2VW-01

0.1A @ 125 VAC

0.1A @ 30 VDC

D2VW-5

3A @ 125 VAC, 250 VAC